LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 6.2L - Repair Instructions - On Vehicle) >> Valve Lifter Oil Manifold Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: All gasket surfaces should be free of oil or other foreign material during assembly.
    Fig 1: Outer Gasket
    GM1509593Courtesy of GENERAL MOTORS CORP.
  1. Place the service gasket (1) onto the valve lifter oil manifold.
    2. Fig 2: Valve Lifter Oil Manifold
    GM1509591Courtesy of GENERAL MOTORS CORP.
  2. Install the valve lifter oil manifold (1) to the engine.
    3. CAUTION: Refer to Fastener Caution
  3. Install the valve lifter oil manifold bolts (2) and tighten to 25 N.m (18 lb ft).
  4. Connect the engine harness electrical connector (1) to the oil pressure sensor.
  5. Install the intake manifold. Refer to Intake Manifold Replacement 
scientia non olet · About LEMON Manuals