LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 6.2L - Repair Instructions - On Vehicle) >> Engine Oil Pressure Sensor and/or Switch Replacement (L99/LS3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Servicing Oil Pressure Sensor/Switch
    GM1658870Courtesy of GENERAL MOTORS CORP.
  1. If installing the old sensor, apply threadlocker sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.
    2. CAUTION: Refer to Fastener Caution .
  2. Using the J 41712  (1), install the oil pressure sensor/switch. See Special Tools . Tighten the engine oil pressure sensor to 20 N.m (15 lb ft).
    3. Fig 2: Oil Pressure Sensor/Switch Electrical Connector
    GM1656451Courtesy of GENERAL MOTORS CORP.
  3. Reconnect the oil pressure sensor/switch electrical connector (2).
    4. Fig 3: View Of Vacuum Brake Booster Hose
    GM63936Courtesy of GENERAL MOTORS CORP.
  4. Install the vacuum hose for the power brake booster.
  5. Install the left engine sight cover.
scientia non olet · About LEMON Manuals