LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 6.2L - Repair Instructions - On Vehicle) >> Engine Oil Level Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Sensor
    GM260123Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the drain plug and tighten to 25 N.m (18 lb ft).
  2. Install the engine oil level sensor. Tighten the sensor to 20 N.m (15 lb ft).
    3. Fig 2: View Of Oil Level Sensor & CKP Sensor Electrical Connector
    GM1235682Courtesy of GENERAL MOTORS CORP.
  3. Reconnect the electrical connector (3).
  4. Lower the vehicle.
  5. Refill the engine. Refer to Approximate Fluid Capacities .
scientia non olet · About LEMON Manuals