LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 6.2L - Repair Instructions - On Vehicle) >> Engine Mount Replacement - Right Side

Engine Mount Replacement - Right Side

WARNING: This page is about a different variant/trim than selected.
Fig 1: Engine Mount - Right Side
GM2143721Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Engine Mount Fastener
CAUTION: Refer to Component Fastener Tightening Caution .

Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Position a screw jack and a block of wood under the engine oil pan.

Tighten:  80 N.m (59 lb ft)
2 Engine Mount Fastener
Procedure: 
The engine mounts must be replaced once loosened or removed.

Tighten:  80 N.m (59 lb ft)
3 Engine Mount

Procedure

  1. Using the screw jack, raise the engine enough to remove the engine mount.
  2. Install the new right and left engine mount lower nut first.
scientia non olet · About LEMON Manuals