LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 6.2L - Repair Instructions - On Vehicle) >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the starter. Refer to Starter Replacement (LS3/L99) .
    2. Fig 1: View Of Special Tool & Bolts
    GM1658136Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the J 42386-A  (1) and bolts. See Special Tools . Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation. Tighten the J 42386-A  bolts to 50 N. See Special Tools .m (37 lb ft).
  3. Remove the camshaft position (CMP) actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
    4. Fig 2: View Of CMP Actuator Solenoid Valve
    GM1670622Courtesy of GENERAL MOTORS CORP.
    WARNING: Refer to Camshaft Position Actuator Removal and Installation Warning .
  4. Remove the CMP actuator solenoid valve (234).
  5. Discard the solenoid valve.
scientia non olet · About LEMON Manuals