LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 6.2L - Repair Instructions) >> Repair Instructions >> Fuel Tank Draining >> Adding The Drained Fuel to The Fuel Tank for Method 1

Adding The Drained Fuel to The Fuel Tank for Method 1

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Tank Draining Equipment
    GM2195590Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank drain hose (3) J 45004  from the fuel flapper door holder (2) J 42960-2  .
  2. Remove the fuel flapper door holder (2) J 42960-2  from the fuel tank fuel filler pipe (1).
    3. Fig 2: Fuel Filler Hose & Clamps
    GM2194792Courtesy of GENERAL MOTORS CORP.
    WARNING: Never drain or store fuel in an open container. Always use an approved fuel storage container in order to reduce the chance of fire or explosion.
  3. Install the fuel filler hose (2) to the vehicle.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the retaining hose clamp (3) to the fuel filler hose (2) and tighten to 4 N.m (35 lb in).
  5. Install the retaining hose clamp (1) to the fuel filler hose (2) and tighten to 4 N.m (35 lb in).
  6. Install the right rear wheel. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle to the ground. Refer to Lifting and Jacking the Vehicle .
  8. Add the drained fuel to the fuel tank.
  9. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals