LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - AISIN AY6) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transmission Mount Components
    GM2196674Courtesy of GENERAL MOTORS CORP.
    NOTE: The engine mounts must NOT bend or deflect from the vertical position, damage to the mount will occur.
  1. Install the transmission mount (5) to the transmission.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the two transmission mount bolts (1) and tighten to 58 N.m (43 lb ft).
  3. Install the transmission support (4).
  4. Install the four transmission support bolts (2) and tighten to 58 N.m (43 lb ft).
  5. Install the transmission mount nuts (3) and tighten to 58 N.m (43 lb ft).
  6. Remove the support from under the transmission.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals