LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - AISIN AY6) >> Repair Instructions - On Vehicle >> Transmission Fluid Replacement >> Draining Procedure

Draining Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Transmission Fluid Plugs & Washers
    GM1979741Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Clean away any dirt and debris from around the transmission fluid drain plug area.
  3. Position an appropriate container below the transmission drain plug.
  4. Remove the transmission fluid drain plug (4) and washer (3). Discard the washer.
  5. Allow the transmission fluid to drain into the container.
    6. CAUTION: Refer to Component Fastener Tightening Caution .
  6. Install the transmission fluid drain plug (4) and a NEW washer (3) then tighten to 37 N.m (27 lb ft).
  7. Remove the container used to catch the used transmission fluid from under the vehicle.
scientia non olet · About LEMON Manuals