Transmission Fluid Level Inspection
WARNING: This page is about a different variant/trim than selected.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
- Clean any dirt from around the fill plug (1).
- Remove the transmission fill plug (1) and washer (2) from the transmission.
- Check that the transmission fluid level is even with the bottom of the fill plug hole.
- Add transmission fluid, if necessary.
- Inspect the fill plug washer (2) and replace if necessary.
- Install the transmission fill plug (1) and washer (2) then tighten to 37 N.m (27 lb ft).
- Lower the vehicle.
CAUTION:
Refer to Component Fastener Tightening Caution
.