Rear Case Disassemble

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Oil Trough

Courtesy of GENERAL MOTORS CORP.

Fig 2: View Of Bearing Retainer, Bolt & Gasket

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing Counter Gear Roller Bearing

Courtesy of GENERAL MOTORS CORP.

NOTE: Case must be held down firmly to remove the bearing.

Using J 26941: remover (2) and J 2619-01: slide hammer (1), remove and discard the counter gear roller bearing (138).

Fig 4: Removing Shift Shaft Bearing & Output Shaft Bearing Race From Rear Case

Courtesy of GENERAL MOTORS CORP.

Using DT-47722: bushing remover, remove the shift shaft bearing (25) from the case.
Remove the output shaft bearing race (139).