LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - AISIN AY6) >> Repair Instructions - Off Vehicle >> Transmission Case Assemble >> Rear Case Assemble

Rear Case Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Bearing
    GM1481564Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure that the rear case housing installation surfaces are free of dirt and sealant.
  1. Apply gear oil to new bearing. Use DT-47726:  installer to install new bearing (138).
    2. Fig 2: View Of Bearing Retainer, Bolt & Gasket
    GM1467809Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the bearing retainer (21) and bolt (38) and tighten to 11.3 N.m (100 lb in).
  3. Install the gasket (29).
    4. Fig 3: View Of Oil Trough
    GM1467807Courtesy of GENERAL MOTORS CORP.
  4. Install the oil trough (17).
    5. Fig 4: Installing Bearing Into Rear Case
    GM1481561Courtesy of GENERAL MOTORS CORP.
  5. Using DT-47722:  remover/installer, install the bearing (25) in the rear case.
    6. Fig 5: Installing Tapered Bearing Race
    GM1481563Courtesy of GENERAL MOTORS CORP.
  6. Using DT-47725:  installer, install the tapered bearing race (139).
scientia non olet · About LEMON Manuals