LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Mechanical - 6.2L - Repair Instructions - Off Vehicle (3 Of 3)) >> Throttle Body Assembly Installation

Throttle Body Assembly Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing Throttle Body
    GM1875999Courtesy of GENERAL MOTORS CORP.
    NOTE: DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.
  1. Install the throttle body gasket (509) to the intake manifold. Align the locating tab of the gasket with the notch in the manifold.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the throttle body (508) and bolts (538). Tighten the throttle body bolts to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals