LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Mechanical - 6.2L - Repair Instructions - Off Vehicle (3 Of 3)) >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Level Indicator & Tube
    GM1401956Courtesy of GENERAL MOTORS CORP.
  1. Inspect the O-ring seal (421) for cuts or damage. If the oil level indicator tube O-ring seal is not cut or damaged, it may be used again.
  2. Lubricate the O-ring seal with clean engine oil.
  3. Install the O-ring seal onto the oil level indicator tube (420).
  4. Install the oil level indicator tube into the engine block and rotate into proper position.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the tube bolt (419) and tighten to 25 N.m (18 lb ft).
  6. Install the oil level indicator (418) into the tube.
scientia non olet · About LEMON Manuals