LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 6.2L - Repair Instructions - Off Vehicle (2 Of 3)) >> Oil Pan Cleaning and Inspection

Oil Pan Cleaning and Inspection

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Filter Fitting
    GM1565281Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil filter fitting (438) as required.
    2. Fig 2: Oil Pressure Relief Valve & Washer
    GM1593663Courtesy of GENERAL MOTORS CORP.
  2. Remove the active fuel management oil pressure relief valve (455) and washer (458).
    3. Fig 3: Ball & Spring
    GM1565291Courtesy of GENERAL MOTORS CORP.
  3. Inspect the active fuel management oil pressure relief valve for proper operation. Lightly depress the ball (2). The valve spring (1) should seat the ball to the proper closed position.
    4. Fig 4: Oil Level Sensor & O-Ring
    GM1593666Courtesy of GENERAL MOTORS CORP.
  4. Remove the oil level sensor and O-ring.
    5. Fig 5: Bolts & Baffle
    GM1565289Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolts (427) and baffle (428).
  6. Clean the oil pan in solvent.
    7. WARNING: Refer to Safety Glasses and Compressed Air Warning .
  7. Dry the oil pan with compressed air.
    8. Fig 6: Oil Pan Components
    GM1565292Courtesy of GENERAL MOTORS CORP.
  8. Inspect the oil pan for the following conditions:
    • Damaged gasket surfaces (1)
    • Restrictions within the oil passages (2) of the pan
    • Damaged oil filter seal surface (3)
    • Threaded bolt holes (4) for damage
    9. Fig 7: Bolts & Baffle
    GM1565289Courtesy of GENERAL MOTORS CORP.
  9. Install the baffle (428) and baffle bolts (427).
    10. CAUTION: Refer to Fastener Caution .
  10. Tighten the baffle bolts (427) to 12 N.m (106 lb in).
    11. Fig 8: Oil Level Sensor & O-Ring
    GM1593666Courtesy of GENERAL MOTORS CORP.
  11. Install the oil level sensor O-ring seal.
  12. Install the oil level sensor and tighten to 20 N.m (15 lb ft).
    13. Fig 9: Oil Pressure Relief Valve & Washer
    GM1593663Courtesy of GENERAL MOTORS CORP.
  13. Install the active fuel management oil pressure relief valve (455) and washer (458).
  14. Tighten the active fuel management oil pressure relief valve (455) to 27 N.m (20 lb ft).
    15. Fig 10: Oil Filter Fitting
    GM1565281Courtesy of GENERAL MOTORS CORP.
  15. Install the oil filter fitting (438) as required.
  16. Tighten the oil filter fitting to 55 N.m (40 lb ft).
scientia non olet · About LEMON Manuals