LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 6.2L - Repair Instructions - Off Vehicle (2 Of 3)) >> Engine Coolant Air Bleed Pipe and Hole Cover Cleaning and Inspection

Engine Coolant Air Bleed Pipe and Hole Cover Cleaning and Inspection

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not use the engine coolant air bleed pipe seals again. Upon installation of the pipe, install NEW seals.
  1. Remove the seals (308) from the pipe.
    2. Fig 2: Coolant Air Bleed Pipe
    GM1552473Courtesy of GENERAL MOTORS CORP.
  2. Clean the pipe in solvent.
    3. WARNING: Refer to Safety Glasses and Compressed Air Warning .
  3. Dry the pipe with compressed air.
  4. Inspect the pipe for damaged sealing surfaces (1, 2) or restrictions within the pipe (3).
scientia non olet · About LEMON Manuals