Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, command the appropriate cylinder deactivation solenoid ON and OFF while observing the following status parameters with a scan tool:
- Cylinder 1, 4, 6, or 7 Deactivation Solenoid Valve Control Circuit Open Test Status
- Cylinder 1, 4, 6, or 7 Deactivation Solenoid Valve Control Circuit Low Voltage Test Status
- Cylinder 1, 4, 6, or 7 Deactivation Solenoid Valve Control Circuit High Voltage Test Status
Each parameter should display OK or Not Run
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
NOTE:
DTC P3401, P3425, P3441, and P3449 sets with an open ignition circuit fuse.