LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the clutch pedal position sensor electrical connector.
    2. Fig 1: Clutch Master Cylinder Push Rod & Clutch Pedal Pin
    GM2195809Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the clutch master cylinder push rod (1) from the clutch pedal pin (2).
    3. Fig 2: Clutch Fluid Reservoir, Actuator Pipe Assembly & Pedal Fasteners
    GM2195812Courtesy of GENERAL MOTORS CORP.
  3. Remove the clutch fluid reservoir (1) hose from the clutch pedal assembly, then plug hose.
    4. IMPORTANT: Cap the line to prevent fluid from entering the vehicle, place shop towels over the carpeting to prevent damage.
  4. Disconnect the clutch actuator pipe assembly (2) from the clutch pedal assembly.
  5. Remove the clutch pedal fasteners (3) from the cowl.
    6. Fig 3: I/P Clutch Pedal Fasteners
    GM2195811Courtesy of GENERAL MOTORS CORP.
  6. Remove the two clutch pedal fasteners (1) from the I/P.
  7. Remove the clutch pedal assembly from the vehicle.
  8. If replacing the pedal, transfer components as necessary.
scientia non olet · About LEMON Manuals