Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Clutch Master Cylinder Push Rod & Clutch Pedal Pin

Courtesy of GENERAL MOTORS CORP.

Disconnect the clutch master cylinder push rod (1) from the clutch pedal pin (2).

Fig 2: Clutch Fluid Reservoir, Actuator Pipe Assembly & Pedal Fasteners

Courtesy of GENERAL MOTORS CORP.

Remove the clutch fluid reservoir (1) hose from the clutch pedal assembly, then plug hose.
Disconnect the clutch actuator pipe assembly (2) from the clutch pedal assembly.

Fig 3: Clutch Master Cylinder Fasteners (Right Side)

Courtesy of GENERAL MOTORS CORP.

Remove the two clutch master cylinder fasteners (1) from the right side of the clutch pedal assembly.

Fig 4: Clutch Master Cylinder Fasteners (Left Side)

Courtesy of GENERAL MOTORS CORP.

Remove the two clutch master cylinder fastener (1) from the left side of the clutch pedal assembly.

Fig 5: Clutch Master Cylinder & Spacer

Courtesy of GENERAL MOTORS CORP.

Remove the clutch master cylinder (1) and the spacer (2) from the clutch pedal assembly.