LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays & Gauges >> Diagnostic Information and Procedures >> DTC P0464 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector X2 at the K20 Engine Control Module.
  2. Ignition ON, test for less than 0.3 V between the low reference circuit terminal 9 and ground.
    • If greater than the specified range, test both the low reference circuit and the signal circuits terminal 26 and 36 for a short to voltage. If the circuit tests normal, replace the appropriate fuel level sensor.
  3. Ignition OFF, test for infinite resistance between the low reference circuit terminal 9 and ground.
    • If less than the specified range, test both the low reference circuit and the signal circuits terminal 26 and 36 for a short to voltage. If the circuit tests normal, replace the appropriate fuel level sensor.
  4. Test for 20-300 Ω between the signal circuit terminal 36 and the low reference circuit terminal 9.
    • If not within the specified range, test both the signal circuit and then low reference circuit or an open/high resistance. If the circuit tests normal, replace the G12 Fuel Pump.
  5. If all circuits test normal, test or replace the K20 Engine Control Module.
scientia non olet · About LEMON Manuals