Instrument Cluster Replacement (Enclave)

Fig 1: Identifying Instrument Cluster (Enclave)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the instrument cluster trim plate applique. Refer to Instrument Panel Cluster Trim Plate Applique Replacement (Enclave) .
1	Instrument Cluster Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
2	Instrument Cluster Assembly Procedure Disconnect the electrical connections. After replacing the instrument panel cluster, remove the instrument panel cluster fuse for a few seconds and then install the fuse. Refer to Control Module References for programming and setup information.

Callout

Component Name

Preliminary Procedure:
Remove the instrument cluster trim plate applique. Refer to Instrument Panel Cluster Trim Plate Applique Replacement (Enclave) .

Instrument Cluster Screw (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tighten: 2 N.m (18 lb in)

Instrument Cluster Assembly

Procedure

Disconnect the electrical connections.
After replacing the instrument panel cluster, remove the instrument panel cluster fuse for a few seconds and then install the fuse.
Refer to Control Module References for programming and setup information.