Front Side Door Trim Panel Replacement - Right Side (Traverse)

Fig 1: Identifying Front Side Door Trim Panel - Right Side (Traverse)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the passenger side power door lock and window switch. Refer to Door Lock and Side Window Switch Replacement - Passenger Side (Outlook with RPO AXA) or Door Lock and Side Window Switch Replacement - Passenger Side (with RPO AXE or AXC) or Door Lock and Side Window Switch Replacement - Passenger Side (Enclave with RPO AXE or AXC) .
1	Front Side Door Pull Handle Cover Tip: Install the top portion of the pull handle cover first to ensure tabs are lined up and push the cover in firmly.
2	Front Side Door Inside Handle Bezel Finish Cover
3	Front Side Door Trim Panel Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 6 N.m (18 lb in)
4	Front Side Door Locking Rod Knob Assembly Procedure Ensure the locking rod is in the unlocked position. Use a flat-bladed tool to disengage the detent tab and then remove the knob by pulling upward. When re-installing, push the knob down until the detent tab touches the locking rod opening cover. Push the detent tab into the lock knob to locking rod.
5	Front Side Door Trim Panel Assembly Procedure Use a door trim pad removal tool, or equivalent, at each of the 9 retainer locations to aid in the removal of the trim panel. Disengage the door lock cable. Disconnect the electrical connector.
6	Front Side Door Trim Panel Retainer (Qty: 9)