Liftgate Actuator Replacement

Fig 1: View Of Liftgate Actuator

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the bodyside trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Traverse with TB5) or Quarter Lower Rear Trim Panel Replacement (Traverse without TB4) or Quarter Lower Rear Trim Panel Replacement (Acadia/OUTLOOK with TB5) or Quarter Lower Rear Trim Panel Replacement (Acadia/OUTLOOK without TB4) or Quarter Lower Rear Trim Panel Replacement (Enclave with TB5) or Quarter Lower Rear Trim Panel Replacement (Enclave without TB4) . Disconnect the power liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement .
1	Liftgate Close Actuator Control Module Procedure Disconnect the electrical connector. Cut the tie strap, if equipped.
2	Liftgate Close Actuator Motor Control Module Bolt (Qty: 5) CAUTION: + Refer to Fastener Caution . Tighten: 9 N.m (80 lb in)
3	Liftgate Close Actuator Control Module Procedure: Reprogram liftgate module. Refer to Liftgate Calibration .