LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LT, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays & Gauges >> Diagnostic Information and Procedures >> DTC P0462 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the fuel level sensor.
  2. Ignition ON, verify that the scan tool fuel tank level remaining parameter is less than 4 percent.
    • If greater than the specified value, test the signal circuit terminal D for a short to ground. If the circuit tests normal, replace the ECM.
  3. If all circuits test normal, test or replace the fuel level sensor.
scientia non olet · About LEMON Manuals