12-Volt Quarter Trim Panel Accessory Power Receptacle Replacement

12-Volt Quarter Trim Panel Accessory Power Receptacle Replacement

Removal Procedure

1. Partially remove the body side trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side (Service and Repair).




2. Disconnect the electrical connector from the 12-volt outlet assembly.




3. Remove the threaded ring and lock washer from the outlet.
4. Remove the outlet assembly from the vehicle.

Installation Procedure

1. Install the outlet assembly properly indexed to the body side trim panel.




2. Install the lock washer and threaded ring.




3. Connect the electrical connector.
4. Install the body side trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side (Service and Repair).