Garage Door Opener Transmitter: Service and Repair

Garage Door Opener Replacement

Removal Procedure




1. Remove the overhead console. Refer to Roof Console Replacement (Service and Repair).
2. Disconnect the electrical connector from the garage door opener (3).
3. Remove the 3 retaining screws from the garage door opener.
4. Remove the garage door opener from the overhead console.
5. Remove the button assembly from the overhead console.

Installation Procedure




1. Install the button assembly to the overhead console.
2. Install the garage door opener to the overhead console. Fully recess the light indicator into the opening (1).





Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the 3 retaining screws to the garage door opener.

Tighten the screws to 0.8 Nm (7 lb in).

4. Connect the electrical connector to the garage door opener (3).
5. Install the overhead console. Refer to Roof Console Replacement (Service and Repair).