Driven Sprocket Support Bearing Assemble

Driven Sprocket Support Bearing Assemble

Special Tools
* J 34126 - Driven Sprocket Bearing Installer and Remover
* J 8092 - Driver Handle

For equivalent regional tools, refer to Special Tools (Tools and Equipment).





Note: Position the driven sprocket support bearing assembly so that markings on the edge are facing up.

Use J 34126 - bearing installer and remover (2) , J 8092 - driver handle (1) and a hammer in order to seat the driven sprocket support bearing assembly flush with or below the driven sprocket support assembly (609) hub.