10. Intake Manifold Removal

Intake Manifold Removal





Important:
* The intake manifold, throttle body, fuel injection rail, and fuel injectors may be removed as an assembly. If not servicing the individual components, remove the manifold as a complete assembly.
* DO NOT use the intake manifold-to-cylinder head gaskets again.

1. Remove the manifold absolute pressure (MAP) sensor (714) and bolt (736).
2. Remove the seal (715) from the sensor, as required.




3. Remove the intake manifold bolts (512).
4. Remove the intake manifold (500).




5. Remove the intake manifold gaskets (514).
6. Discard the intake manifold gaskets.