LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 1207 (Power Seat System) >> Repair Instructions >> Front Seat Adjuster Replacement (with HP2)

Front Seat Adjuster Replacement (with HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Seat Adjuster Replacement (with HP2)
GM1966914Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the front seat. Refer to Front Seat Replacement - Bucket (without HP2) or Front Seat Replacement - Bucket (with HP2) .
  2. Remove the front seat back cushion cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement (with HP2) or Front Seat Back Cushion Cover and Cushion Pad Replacement (without HP2) .
  3. Remove the front seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement (with HP2) or Seat Cushion Trim Cover and Pad Replacement (without HP2) .
1 Front Seat Back Frame Bolt (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:  50 N.m (37 lb ft)
2 Front Seat Adjuster Assembly

Procedure

  1. Disconnect the lumbar actuator assembly from the seat back frame and lumbar support.
  2. When replacing the seat adjuster assembly, transfer components as necessary.
scientia non olet · About LEMON Manuals