Inflatable Restraint Passenger Presence System Replacement - Front (with HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inflatable Restraint Passenger Presence System - Front (with HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket (without HP2) or Front Seat Replacement - Bucket (with HP2) . Remove the seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement (with HP2) or Seat Cushion Trim Cover and Pad Replacement (without HP2) .
1	Inflatable Restraint Front Passenger Presence Sensor Retainer (Qty: 2)
2	Inflatable Restraint Front Passenger Presence Sensor Procedure Lay the seat on its side. Unhook the connector from retainer on seat frame and push up through seat pan. Disconnect and remove the sensor.
3	Inflatable Restraint Front Passenger Presence Module Rivets (Qty: 2) Procedure: Drill out the rivets to remove and install using new rivets.
4	Inflatable Restraint Front Passenger Presence Module Procedure The inflatable restraint passenger presence module must be replaced as a kit that also includes the sensor assembly. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .