Front Floor Console Replacement (Cadillac)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Floor Console Assembly & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the 2 front seats. Refer to Front Seat Replacement - Bucket (without HP2) or Front Seat Replacement - Bucket (with HP2) . Remove the right and left instrument panel lower trim panels. Refer to Instrument Panel Lower Center Trim Replacement (Cadillac) . Remove the front floor console bezel. Refer to Floor Console Bezel Replacement (Cadillac) .
1	Front Floor Console Assembly Bolts/Screws NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Front Floor Console Assembly Tip: Disconnect the electrical connectors to the console assembly. With the aid of an assistant, remove the console from the vehicle. If replacing the console assembly, transfer all necessary components.

Callout

Component Name

Preliminary Procedures

Remove the 2 front seats. Refer to Front Seat Replacement - Bucket (without HP2) or Front Seat Replacement - Bucket (with HP2) .
Remove the right and left instrument panel lower trim panels. Refer to Instrument Panel Lower Center Trim Replacement (Cadillac) .
Remove the front floor console bezel. Refer to Floor Console Bezel Replacement (Cadillac) .

Front Floor Console Assembly Bolts/Screws

NOTE: Refer to Fastener Notice .

Tighten: 2 N.m (18 lb in)

Front Floor Console Assembly
Tip:

Disconnect the electrical connectors to the console assembly.
With the aid of an assistant, remove the console from the vehicle.
If replacing the console assembly, transfer all necessary components.