LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 1178 (Seat Hardware, Seat Trim And Upholstery) >> Repair Instructions >> Rear Seat Riser Finish Cover Replacement (Tahoe/Yukon/Escalade w/Split Bench)

Rear Seat Riser Finish Cover Replacement (Tahoe/Yukon/Escalade w/Split Bench)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Seat Riser Finish Covers & Screws
GM1685303Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Flip and fold the rear seat forward.
  2. Remove the rear seat floor filler trim cover.
1 Rear Seat Riser Finish Cover Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  2 N.m (18 lb in)
2 Rear Seat Riser Finish Cover (Qty: 2)
3 Rear Seat Riser Finish Cover (Qty: 2)
scientia non olet · About LEMON Manuals