Driver or Passenger Seat Back Cushion Finish Panel Replacement (with HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Seat Back Cushion Finish Panel (With HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Disconnect the lower portion of the seat back finish panel from the seat frame and lift upward to gain access to the screws.
1	Front Seat Back Cushion Filler Panel Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Front Seat Back Cushion Filler Panel Procedure Insert a flat bladed tool between the seatback panel and the seat back cushion frame to release the middle retainer tabs on each side. Pull away from the seat at the bottom edge first and disengage the top of the panel from the seat back frame.

Callout

Component Name

Preliminary Procedure:
Disconnect the lower portion of the seat back finish panel from the seat frame and lift upward to gain access to the screws.

Front Seat Back Cushion Filler Panel Screw (Qty: 2)

NOTE: Refer to Fastener Notice .

Tighten: 2 N.m (18 lb in)

Front Seat Back Cushion Filler Panel

Procedure

Insert a flat bladed tool between the seatback panel and the seat back cushion frame to release the middle retainer tabs on each side.
Pull away from the seat at the bottom edge first and disengage the top of the panel from the seat back frame.