Center Pillar Lower Garnish Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Center Pillar Lower Garnish Molding Assembly & Retainers

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove front door sill plate. Refer to Front Side Door Sill Plate Replacement . Remove rear door sill plate. Refer to Rear Side Door Sill Plate Replacement (Standard Wheelbase) or Rear Side Door Sill Plate Replacement (Extended Wheelbase) .
1	Center Pillar Lower Garnish Molding Assembly Tip: Ensure seat belt webbing does not become trapped during installation. Tab to be fully seated and installed prior to retainer.
2	Center Pillar Lower Garnish Molding Retainer (Qty: 2)

Callout

Component Name

Preliminary Procedures

Remove front door sill plate. Refer to Front Side Door Sill Plate Replacement .
Remove rear door sill plate. Refer to Rear Side Door Sill Plate Replacement (Standard Wheelbase) or Rear Side Door Sill Plate Replacement (Extended Wheelbase) .

Center Pillar Lower Garnish Molding Assembly
Tip:

Ensure seat belt webbing does not become trapped during installation.
Tab to be fully seated and installed prior to retainer.

Center Pillar Lower Garnish Molding Retainer (Qty: 2)