LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala Police >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: Refer to Automatic Transmission Range Selector Cable Warning .
  1. Remove the air cleaner outlet duct. Refer to the following:
    2. Fig 1: View Of Automatic Transaxle Range Selector Cable At Wiring Harness Clip
    GM161181Courtesy of GENERAL MOTORS CORP.
    Fig 2: View Of Transaxle Range Selector Cable & Shift Lever
    GM629690Courtesy of GENERAL MOTORS CORP.
  2. Remove the automatic transaxle range selector cable from the wiring harness clip or strap.

    Remove the automatic transaxle range selector cable retainer.

    3. Fig 3: Identifying Automatic Transaxle Range Selector Cable To Cable Bracket
    GM629687Courtesy of GENERAL MOTORS CORP.
  3. Remove the automatic transaxle range selector cable from the automatic transaxle range selector lever.
  4. Remove the automatic transaxle range selector cable from the automatic transaxle range selector cable bracket.
    5. Fig 4: View Of Automatic Transaxle Range Selector Cable Retainer At Console Shift Control
    GM161221Courtesy of GENERAL MOTORS CORP.
  5. If equipped with a floor console, remove the front floor console. Refer to Front Floor Console Replacement .
  6. Pull the carpet back to expose the automatic transaxle range selector cable. Refer to Floor Panel Carpet Replacement (Impala) .
  7. Remove the automatic transaxle range selector cable retainer from the console shift control.
    8. Fig 5: View Of Automatic Transaxle Range Selector Cable At Console Shift Control
    GM161220Courtesy of GENERAL MOTORS CORP.
  8. Remove the automatic transaxle range selector cable from the console shift control.
  9. Remove the automatic transaxle range selector cable from the console shift control bracket.
    10. Fig 6: View Of Automatic Transmission Range Selector Cable At Shift Control Lever
    GM161185Courtesy of GENERAL MOTORS CORP.
  10. If equipped with a steering column shift control, remove the left knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement .
    11. Fig 7: View Of Automatic Transmission Range Selector Cable At Cowl
    GM161182Courtesy of GENERAL MOTORS CORP.
  11. Install a piece of mechanics wire to the end of the automatic transmission range selector cable.
  12. Remove the automatic transmission range selector cable through the hole in the cowl.
  13. Remove the automatic transmission range selector cable from the shift control lever.
scientia non olet · About LEMON Manuals