LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala Police >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Vehicle Speed Sensor Assemble

Vehicle Speed Sensor Assemble

    Fig 1: View Of VSS & O-Ring
    GM10711Courtesy of GENERAL MOTORS CORP.
    NOTE: Handle the vehicle speed sensor assembly carefully.
  1. Inspect the vehicle speed sensor assembly (10) and the vehicle speed sensor O-ring seal (11) for the following conditions:
    • Damaged connector
    • Cracked housing
    • Signs of rotor damage
    • Cuts or nicks on the O-ring seal
  2. Install a new O-ring seal (11) on the vehicle speed sensor assembly (10).
    3. Fig 2: Identifying Vehicle Speed Sensor (VSS)
    GM10516Courtesy of GENERAL MOTORS CORP.
  3. Install the vehicle speed sensor assembly (10) into the case extension.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the vehicle speed sensor bolt (9) and tighten to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals