LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala Police >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Thermo Element Adjustment >> Adjustment

Thermo Element Adjustment: Adjustment

    Fig 1: View Of Thermo Element, Plate & Plate Pins
    GM13015Courtesy of GENERAL MOTORS CORP.
  1. Remove the thermo element plate pins (120).
  2. Remove the thermo element (121) and the thermo element plate (122).
    3. Fig 2: Using J 34094-A To Set The Height Of The Thermo Element Plate Center Pin
    GM13016Courtesy of GENERAL MOTORS CORP.
  3. Use J 34094-A:  height gage in order to set the height of the thermo element plate center pin (123).
  4. Install the thermo element plate (122).
  5. Use J 34094-A:  height gage in order to set the height of the thermo element plate pin (120) that is farthest from the accumulators.
  6. Use J 34094-A:  height gage in order to set the height of the second thermo element plate pin (120).
    7. Fig 3: View Of Thermo Element, Plate & Plate Pins
    GM13015Courtesy of GENERAL MOTORS CORP.
  7. Carefully install the thermo element (121) between the two thermo element plate pins (120).
  8. The V in the thermo element (121) must contact the thermo element plate (123).
scientia non olet · About LEMON Manuals