LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala Police >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Input Clutch Housing Fluid Seal Ring Assemble >> Assembly

Input Clutch Housing Fluid Seal Ring Assemble: Assembly

    Fig 1: Installing J 34741-1 Into The Input Clutch Housing
    GM10655Courtesy of GENERAL MOTORS CORP.
  1. Install J 34741-1:  seal installer into the input clutch housing (632). Adjust J 34741-1:  seal installer so that the bottom of the seal installer aligns with the lowest seal ring groove.
  2. Use transmission fluid in order to lubricate the oil seal ring for the input clutch housing. Position the ring on the J 34741-1:  seal installer.
    3. Fig 2: Using J 34741-2 & J 34741-1 To Install Seal Rings
    GM10657Courtesy of GENERAL MOTORS CORP.
  3. Position J 34741-2:  Input Shaft Seal Pusher onto the J 34741-1:  seal installer. Push the seal (628) into the seal ring groove.
    4. Fig 3: Locating Second & Third Seal Rings
    GM10656Courtesy of GENERAL MOTORS CORP.
  4. Repeat this procedure for the second and the third seal rings (628).
    5. Fig 4: Installing J 34741-3 Over The Seals
    GM10658Courtesy of GENERAL MOTORS CORP.
  5. Remove the input seal installer.
  6. Use a twisting motion in order to assemble J 34741-3:  seal compressor over the seals.
  7. Leave J 34741-3:  seal compressor in place until the input clutch housing assembly (632) is assembled into the transmission.
scientia non olet · About LEMON Manuals