LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala Police >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Drive Sprocket Support Assemble >> Assembly

Drive Sprocket Support Assemble: Assembly

    Fig 1: Pressing In Drive Sprocket Support Bearing With J 8092 & J 28677
    GM10582Courtesy of GENERAL MOTORS CORP.
  1. Assemble J-28677:  bearing installer and J-8092:  driver handle.
  2. Lubricate drive sprocket support bearing (521) with J-36850:  lubricant.
    3. NOTE: When installing the new bearing the part number should be visible (facing upward).
  3. Using the assembled tool, press in the drive sprocket support bearing (521).
    4. Fig 2: Locating Drive Sprocket Support Assembly
    GM10583Courtesy of GENERAL MOTORS CORP.
  4. Install the drive sprocket support assembly (522).
    5. CAUTION: Refer to Fastener Caution .
  5. Install the four drive sprocket support bolts (524) and tighten to 25 N.m (18 lb ft).
scientia non olet · About LEMON Manuals