LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala Police >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Case Components Assemble

Case Components Assemble

    Fig 1: Installing Oil Pressure Test Hole Plug & Vent Assembly
    GM48694Courtesy of GENERAL MOTORS CORP.
  1. Use a hammer and a punch in order to install the vent assembly (37), if necessary.
  2. Apply sealant GM P/N 12345382 to the oil pressure test hole plug (38).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the oil pressure test hole plug (38) and tighten to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals