LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala LTZ >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Connector Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Transaxle Oil Cooler Fittings
    GM627406Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: The correct thread engagement is critical. Crossthreaded fittings can achieve proper tightness and still leak.
  1. Install the transaxle oil cooler fittings (28, 29) to the transaxle.

    Tighten:  Tighten the fittings to 38 N.m (28 lb ft).

  2. Install the transaxle oil cooler hoses to the transaxle oil cooler fittings. Refer to Transmission Fluid Cooler Hose/Pipe Replacement .
  3. Lower the vehicle.
    4. CAUTION: Refer to Transmission Overfill Caution .
  4. Adjust the fluid level.
  5. Inspect for fluid leaks. Refer to Fluid Leak Diagnosis .
  6. Remove the drain pan from under the vehicle.
scientia non olet · About LEMON Manuals