LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala LTZ >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Rear Compartment Lid Strut Replacement >> Removal Procedure

Removal Procedure

WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
CAUTION: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.
    Fig 1: Removing & Installing Rear Compartment Lid Strut
    GM738146Courtesy of GENERAL MOTORS CORP.
  1. Open and support the rear compartment lid.
  2. Using a small flat-bladed tool, release the clip retaining the rear compartment lid assist rod to the lower assist rod ball stud.
  3. Using a small flat-bladed tool, release the clip retaining the rear compartment assist rod to the upper assist rod ball stud.
  4. Remove the rear compartment lid assist rod from the vehicle.
scientia non olet · About LEMON Manuals