LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 4T45-E - DTC P0218 To DTC P2764) >> DTC P2534 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the TCM.
  2. Test for less than 10 ohm of resistance between the ground circuit terminal 49 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Verify that a test lamp illuminates between the B+ circuit terminal 32 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 31 and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  5. If all circuits test normal, replace the TCM.