Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Perform the Transmission Fluid Check
to verify correct fluid level and condition. The transmission fluid level should be within the crosshatch band and the transmission fluid should be red or dark brown.
- If the transmission fluid is low or discolored, refer to Automatic Transmission Fluid Filter and Seal Replacement .
- Drive the vehicle while observing the Trans. Fluid Temp. parameter with a scan tool. The Trans. Fluid Temp. parameter should rise by 3°C (5°F) or more.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.