Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

NOTE: The scan tool control of the CMP actuator is inhibited when DTC P0016 or P0017 sets.

Inspect the engine for any recent engine mechanical repairs. An incorrectly installed camshaft, camshaft actuator, camshaft sensor, crankshaft sensor, or timing chain can cause this DTC to set.
Excessive crankshaft endplay can cause this DTC to set.
A crankshaft reluctor wheel that has moved in relationship to top dead center (TDC) on the crankshaft can cause this DTC to set.