LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 2.2L Or 2.4L - DTC P0010 To DTC P0366) >> DTC P0010 or P0013 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Measure the resistance of each CMP actuator solenoid valve assembly. Resistance should be between 8-12 ohms.
  2. Connect a jumper wire between the CMP actuator low reference circuit at the solenoid and a good ground. Connect a fused jumper wire to the CMP actuator high control circuit at the solenoid. Momentarily touch the fused jumper to B+. Observe the spool valve inside the CMP actuator. The spool valve should move from fully closed to fully opened position.
scientia non olet · About LEMON Manuals