LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Knock Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Harness
    GM1622787Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the knock sensor (KS) electrical connector (6).
    3. Fig 2: Identifying Knock Sensor
    GM1578476Courtesy of GENERAL MOTORS CORP.
  3. Remove the KS bolt.
  4. Remove the KS.
scientia non olet · About LEMON Manuals