LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Canister Purge Valve Tube
    GM1623766Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  2. Disconnect the evaporative emission (EVAP) canister purge tube from the purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Disconnect the EVAP purge tube from the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Remove the EVAP canister valve purge tube.
scientia non olet · About LEMON Manuals