LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine/Chassis >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Feed Line
    GM1625417Courtesy of GENERAL MOTORS CORP.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Without CH 48027)  or Fuel Pressure Relief (With CH 48027) .
  2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  3. Disconnect the fuel feed pipe from the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
  4. Cap or plug the fuel pipe and the engine fuel rail to prevent contamination.
    5. Fig 2: Identifying EVAP Line
    GM1625606Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the evaporative emission (EVAP) pipe from the purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Cap or plug the EVAP pipe in order to prevent contamination.
  7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  8. Remove the EVAP canister, if necessary. Refer to Evaporative Emission Canister Replacement .
  9. Disconnect the fuel feed pipe quick connect fitting. Refer to Plastic Collar Quick Connect Fitting Service .
    10. Fig 3: Identifying Fuel/EVAP/Brake Line Brackets
    GM1636707Courtesy of GENERAL MOTORS CORP.
  10. Remove the brake lines from the fuel/EVAP/brake line brackets.
  11. Remove the fuel/EVAP/brake line bracket nuts and remove the brackets from the body studs.
  12. Remove the fuel and EVAP lines from the vehicle.
  13. Open the brackets and remove the EVAP pipe.
scientia non olet · About LEMON Manuals