LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Tank Electrical Connector
    GM1636801Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the evaporative emission (EVAP) canister vent solenoid valve electrical connector (2).
  3. Clean any dirt or debris that may be present around the EVAP canister vent valve.
    4. Fig 2: Identifying Fuel Fill Pipe Hose
    GM1636704Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the fresh air tube quick connect fitting (3) from the EVAP vent solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: Identifying EVAP Vent Solenoid Valve
    GM1637874Courtesy of GENERAL MOTORS CORP.
  5. Disengage the retainer attaching the EVAP vent solenoid valve to the canister.
  6. Remove the vent solenoid valve from the EVAP canister.
scientia non olet · About LEMON Manuals