LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Vent Solenoid Valve
    GM1637874Courtesy of GENERAL MOTORS CORP.
  1. Install the vent solenoid valve to the EVAP canister.
  2. Ensure that the retainer attaching the EVAP vent solenoid valve to the canister is engaged.
    3. Fig 2: Identifying Fuel Fill Pipe Hose
    GM1636704Courtesy of GENERAL MOTORS CORP.
  3. Connect the fresh air tube quick connect fitting (3) to the EVAP vent solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 3: Identifying Fuel Tank Electrical Connector
    GM1636801Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister vent solenoid valve electrical connector (2).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals